Installation manual - Ecotype - 33
3.8.2 Installation of the electrical components
Hereafter the required operations for installing the electrical components:
•
Using proper hooking elements, fasten the Control Box on the chassis of the tipper body.
•
Fasten one of the two contact plates on the front part of the tipper body.
•
Fasten the other contact plate on the chassis.
IMPORTANT!
The fastening of the contact plates has to be done making sure that, with the tipper body completely
lowered, both contact plates meet properly.
WARNING!
Make sure that the contacts connect properly to avoid any damage to the wiring system due to a possible
short circuit
EXAMPLE OF ASSEMBLY
The Control Box can be positioned anywhere on the tipper-trailer chassis, provided that it is fastened vertically (as shown in
above figure).
IMPORTANT!
The Control Box has to be fastened vertically on the tipper trailer chassis (see figure) by means of the
supplied connection cables.
For battery connection insert a 70A fuse (not supplied) -
see “wiring diagram” in paragraph 6.1.
WARNING!
Do not power the Control Box with power supplies other than vehicle batteries
or with systems
that have not been authorized by Marcolin Covering
Call us in case of any doubts or problems during installation.
Note:
Any installation made without authorisation by Marcolin Covering s.r.l.
can invalidate the warranty
!
