Mantis ComposT-Twin Series, Руководство пользователя

Страница: 19 / 28

Position the second end cap over the open
end of the drum assembly, so the four round
openings align with the four threaded rods,
and making sure that the vent hole lines up
with the vent hole in the other end cap.
Fit the end cap rim over the edge of the
sheet metal assembly, making sure that the
threaded rods slip through the end cap holes.
Step 37
Place 1/4” flat washer (key #34) over each
threaded rod and thread an acorn nut (key
#25) onto the end of each rod. Tighten acorn
nuts using 7/16” socket wrench.
On the support frame, check axle rod
gears and middle wheels; be sure that
pins are inside of the pin openings of
the gears, and that the wheels are in the
middle of the axle rods.
Check the door position before placing the
drum on the bottom support frame. The door
openings should be on the same side of the
bottom frame as the handle, and latches
should be on the bottom part of the door
opening.
Step 38
Step 39
Step 40
19