Manitou M 26-2 Turbo Serie 3-E3, Руководство оператора

Страница: 152 / 178

3-44
E8 - SEAT BELT
CHECK
Seat belt with two anchoring points
- Check the following points:
t'JYJOHPGUIFBODIPSJOHQPJOUTPOUIFTFBU
t$MFBOOFTTPGUIFTUSBQBOEUIFMPDLJOHNFDIBOJTN
t5SJHHFSJOHPGUIFMPDLJOHNFDIBOJTN
t$POEJUJPOPGUIFTUSBQ DVUTDVSMFEFEHFT
Reeled seat belt with two anchoring points
- Check the points listed above together with the following points:
t5IFDPSSFDUXJOEJOHPGUIFCFMU
t$POEJUJPOPGUIFSFFMHVBSET
t3PMMFSMPDLJOHNFDIBOJTNXIFOUIFTUSBQJTHJWFOBTIBSQUVH
NOTE: After an accident, replace the seat belt.
In no event should the lift truck be used if the seat belt is defective (fixing, locking, cuts, tears, etc.). Repair or replace the seat belt immediately.
E9 - FRONT WHEELS REDUCERS OIL
DRAIN
Place the lift truck on level ground with the I.C. engine stopped and the reducers oil still warm.
Dispose of the drain oil in an ecological manner.
- Drain and change each front wheel reducer.
- Place drain plug 1 (fig. E9) in position A.
- Place a container under the drain plug and unscrew the plug.
- Let the oil drain fully.
- Place the drain port in position B, i.e. in a level port.
- Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) by level port 1 (fig. E9).
- The level is correct when the oil level is flush with the edge of the hole.
- Refit and tighten the drain plug 1 (fig. E9) (tightening torque 34 to 49 N.m).
E10 - REAR AXLE DIFFERENTIAL OIL
DRAIN
M 26-4 Turbo Série 3-E3 M 40-4 Turbo Série 3-E3
M 30-4 Turbo Série 3-E3 M 50-4 Turbo Série 3-E3
Place the lift truck on level ground with the I.C. engine stopped and the differential oil still warm.
Dispose of the drain oil in an ecological manner.
- Place a container under drain plugs 1 (fig. E10) and unscrew them.
- Remove the level plug 2 (fig. E10) and the filler plug 3 (fig. E10) to ensure proper emptying.
- Refit and tighten the drain plugs 1 (fig. E10) (tightening torque 34 to 49 N.m).
- Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) by filler port 3 (fig. E10).
- The level is correct when the oil is level is flush with the edge of port 2 (fig. E10).
- Check for any possible leaks at the drain plugs.
- Refit and tighten the level plug 2 (fig. E10) (tightening torque 34 to 49 N.m) and the filler plug
3 (fig. E10) (tightening torque 34 to 49 N.m).
E9
1
A
B
E10
3
2
1
1 1
647003 EN (03/01/2012)