Manitou M 26-2 Turbo Serie 3-E3, Руководство оператора

Страница: 147 / 178

3-39
D12 - FRONT AXLE DIFFERENTIAL OIL (with cooler of oil)
DRAIN
D13 - FRONT AXLE COOLING CIRCUIT FILTER
CHANGE
Place the lift truck on level ground with the I.C. engine stopped and the differential oil still warm.
DRAINING THE OIL
Dispose of the drain oil in an ecological manner.
- Place a container under drain plugs 1 (fig. D12/1) and unscrew the plugs.
- Remove level and filling plug 2 (fig. D12/1) in order to ensure that the oil is drained properly.
- Refit and tighten drain plugs 1 (fig. D12/1) (tightening torque 34 to 49 N.m).
REPLACEMENT OF THE FILTER
- Unscrew the half clamp 3 (fig. D12/2).
- Unscrew the two hoses 4 (fig. D12/2), remove the two couplings 5 (fig. D12/2) and replace the
filter 6 (fig. D12/2) (see: 3 - MAINTENANCE: FILTERS CARTRIDGES AND BELTS).
Be careful to mount the filter 6 (fig. D11/2) in the same direction as the arrow.
- Retighten the half clamp 3 (fig. D12/2).
FILLING UP THE OIL
- Fill with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) by oil level and filler port 2 (fig.
D12/1) until the oil is flush with the edge of the port, and put back the plug.
- Start the I.C. engine and allow to run for a few minutes to fill the cooling circuit.
- Stop the I.C. engine, wait a few minutes and top-up the level.
- The level is correct when the oil level is flush with the edge of the level and filling port 2 (fig.
D12/1).
- Check for any possible leaks at the drain plugs.
- Refit and tighten the level and filling plug 2 (fig. D12/1) (tightening torque 34 to 49 N.m).
D12/2
4
3
4
5
6
5
D12/1
1
1
2
647003 EN (03/01/2012)