Malibu Boats Response, Руководство пользователя

Страница: 100 / 112

4-16
Miscellaneous
Hardware
Most of the metal hardware on your boat consists of brass, stainless steel, or aluminum
and should be cleaned on a periodic basis with soap and water. In fresh water, metal
fittings and hardware should be sprayed annually with a rust inhibitor such as WD-40,
and every two or three months in saltwater.
DO NOT use cleaners that are not intended for use on stainless steel. Glass, tile, counter
or citrus cleaners can damage hardware permanently. Always follow cleaning, by
applying a high-quality metal polish or automotive wax after cleaning. Test products in
an inconspicuous area before applying to the complete surface, especially if you are not
familiar with the product.
Bilge
The bilge of your boat can accumulate oil and greasy dirt over a period of time and
should be cleaned out periodically. Usually, ordinary soap and water does not remove the
accumulation and something stronger will be needed. Check with your Malibu dealer for
recommendations.
Windows and Windshields
The windows and windshields on your Malibu boat are made of tempered safety glass
and are similar to the windows in your car. The glass will scratch however, and abrasive
cleaners should not be used to clean your windows. Soap and water or automotive glass
cleaners may be used.
Winterizing
When the boating and ski season comes to an end, it is recommended that the boat be
removed from the water and stored. It is extremely important that proper winterizing
procedures are read and followed to ensure longer boat life. Here is our list of suggestions
to keep your boat in top condition:
• Prepare the engine according to the instructions found in your engine owner’s
manual. It our recommendation that you contact your local Malibu dealer for
full winterization procedures.
• Clean and dry the boat interior and exterior thoroughly. Inspect boat hull for
residue and remove any if present.
• Clean the bilge area thoroughly and operate the bilge pump to remove any water
from bilge lines.
• Remove all seat cushions and open all storage areas. Store the seat cushions in a
cool and dry place.
• Cover the boat and store it in a garage or other protected facility.
• If the boat is stored on a trailer, you should block the trailer wheels.
Storage and Winter Lay-up
Due to the problems that can occur from improper winterization, we recommend that you
take your boat to a certified Malibu dealership to perform this task. Without proper
preparation, storage for long periods of time may cause parts of the engine and
transmission to rust due to lack of lubrication. Also, if your boat will be stored in freezing
conditions, water inside these components to include cooling system, heater and shower
could result in major damage to your boat. Damage done due to improper winter storage
will void your warranty. Here is our list of suggestions to keep your boat in top condition.
Chapter 4_08.qxd: Chapter 4 doc.qxd 11/12/07 3:40 PM Page 16