Makita DLS600, Инструкция по эксплуатации

Страница: 34 / 233

34 ENGLISH
►
Fig.61: 1. Saw blade 2. Triangular rule
Adjusting the laser line position
WARNING:
The battery cartridge must be
installed on the tool while adjusting the laser line.
Take extra care not to switch on the tool during
adjustment.
Accidental start up of the tool may result
in serious personal injury.
CAUTION:
Never look directly into the laser
beam. Direct eye exposure to the beam could cause
serious damage to your eyes.
NOTICE:
Check the position of laser line
regularly for accuracy.
NOTICE:
Beware that impacts to the tool. It may
cause the laser line to be misaligned or may cause
damage to the laser, shortening its life.
NOTICE:
Have the tool repaired by a Makita
authorized service center for any failure on the
laser unit.
The movable range of laser line is decided by the range
adjustment screws on both sides.
Perform following procedures to alter the laser line
position.
1. Remove the battery cartridge.
2. Draw a cutting line on the workpiece and place it
on the turn base. At this time, do not secure the
workpiece with a vise or similar securing device.
3. Lower the handle and align the cutting line with
the saw blade.
►
Fig.62: 1. Cutting line
4. Return the handle to the original position and
secure the workpiece with the vertical vise so that
the workpiece does not move from the position
you have determined.
►
Fig.63: 1. Vise
5. Install the battery cartridge to the tool and turn on
the laser switch.
6. Loosen the adjusting screw.
To move the laser
line away from the
blade, turn the range
adjustment screws counterclockwise. To
move the laser line close to the blade, turn
the range adjustment screw
clockwise.
Adjusting the laser line on the left side of the blade
►
Fig.64: 1. Adjusting screw
2. Range
adjustment screw 3. Hex wrench
4. Laser line 5. Saw blade
Adjusting the laser line on the right side of the
blade
►
Fig.65: 1. Range
adjustment screw 2. Hex wrench
3. Laser line 4. Saw blade
7. Slide the adjusting screw to
the position that the
laser line comes onto the cutting line and
then tighten.
NOTE: The movable range of laser line is factory
adjusted within 1 mm from
the side surface of
blade.
Cleaning the laser light lens
The laser light becomes hard to see as the lens for
the laser light gets dirty. Clean the lens for laser light
periodically.
Remove the battery cartridge. Loosen the screw and
pull out the lens. Clean the lens gently with a damp
soft cloth. ►
Fig.66: 1. Screw
►
Fig.67: 1. Lens
NOTICE:
Do not remove the screw which secures
the lens. If the lens does not come out, loosen the
screw further.
NOTICE:
Do not use solvents or any petroleum-
based cleaners on the lens.
After use
After use, wipe off chips and dust adhering to the tool
with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
section titled "Blade guard". Lubricate the sliding
portions with machine oil to prevent rust.
OPTIONAL
ACCESSORIES
WARNING:
These Makita accessories or
attachments are recommended for use with your
Makita tool specified in this manual.
The use of
any other accessories or attachments may result in
serious
personal injury.
WARNING:
Only use the Makita accessory or
attachment for its stated purpose. Misuse of an
accessory or attachment may result in serious
personal
injury.