20
M2 ASSEMBLY GUIDE
BUILDING YOUR FRAME PART
5: MOUNT MOTORS TO FRAME (BAG E)
1. Place motor in left bracket, with cylindrical end toward center.
Slide lock E4 washers over E3 screws and fasten screws through
the front of the motor with a Phillips Screwdriver.
2.Attach E1 motor gear by inserting the E2 grub screw into the
gear hole, aligning with the flat side of the motor shaft, and
tightening with E5 Allen wrench to prevent slipping.
3. Plug six-pin motor wire into motor, connection will only seat
in one direction. Ensure connection is secure and use one of the
shorter blue wires.
4. Repeat steps 1-3 on right side.
Drew’s Note:
The X and Y motors move the M2 back and forth on the frame. If one of your motors
of your M2 doesn’t move during operation, or the M2 generally moves in a strange direction, the first
thing to check are the motor connections. If the wires connecting the X, Y, and Z motors are loose, even
a tiny bit, it will cause your M2 to malfunction.
This work is licensed under the creative commons Attribution
NonCommercial-NoDerivatives 4.0 International license.
Last Updated 11.09.2020
Version 1.14
