Majestic Designer, Инструкция по установке и эксплуатации

Страница: 8 / 56

8
53D0419
PRE-INSTALLATION INFORMATION
IMPORTANT:
PLEASE READ THE FOLLOWING CAREFULLY
Remove any plastic from trim parts before turning the fireplace ON.
It is normal for fireplaces fabricated of steel to give off some expansion and/or contraction
noises during the start up or cool down cycle. Similar noises are found with your furnace heat
exchanger or car engine.
It is not unusual for your MHSC gas fireplace to give off some odor the first time it is burned. This
is due to the curing of the paint and any undetected oil form the manufacturing process.
Please ensure that your room is well ventilated - open all widows.
It is recommended you burn your MHSC fireplace for at least 10 (10) hours the first time you
use it. If the optional fan kit has been installed, place the fan switch in the "OFF" position
during this time.
X
X
X
Y
Y
Y
Z
A
A
B
FP2035
locate fireplace
10/08
Figure 2 -
Locate Gas Fireplace
FP2035
A. Wall Location
Figure 2
Y Minimum distance between a glass panel and a parallel wall = 3
1
/ "
Z Minimum distance between the edge of a glass panel and an adjacent wall = 3"
B. Island Location Figure 2
X Maximum length of horizontal venting = 20'. Refer to the venting section for specific
dimensions.