22
2SWLRQDO$FFHVVRULHV
($6+HLJKW6WDQG
The EAS-2496 Height Stand is in-
tended to be used on a surface plate or
RWKHUVXLWDEO\ÀDWVXUIDFHWRPHDVXUH
workpiece surfaces ranging in height
HOHYDWLRQIURPÀXVKZLWKWKHZRUNVXU
-
face to a maximum height of approxi-
mately 4 3/8"/110mm. The Pocket Surf
probe can be in either its 90° or 180°
“Extended” position.
1. Mount the Pocket Surf unit in the
bracket on the Height Stand using
the captive screw in the base of the
bracket. The screw mates with the
tapped hole in the bottom of the
Pocket Surf housing. Tighten the
screw using a screwdriver or coin;
GRQRWRYHUWLJKWHQ
.
3KRWRJUDSKVKRZV
typical application
XVLQJ6PDOO%RUH
3UREH
2. Position the Height Stand so that
the probe is above the workpiece sur-
face to be measured. Use the Coarse
+HLJKW$GMXVWPHQWWREULQJWKHSUREH
skid and stylus barely in contact with
WKHVXUIDFH8VHWKH)LQH$GMXVWPHQWWR
make the black, scribed Reference Line
on the Probe Mounting Block parallel to
the bottom of the Pocket Surf housing
(as outlined in the
*DJH2SHUDWLRQ
section).
2QFHWKHVHWXSLVFRUUHFWO\DGMXVWHG
and the probe is properly positioned
on the workpiece surface, gently press
and release the “Start” button on the
Pocket Surf unit to make the measure-
ment.
Do not place the probe in
WKH³FORVHG´SRVLWLRQZLWK
WKH3RFNHW6XUI
®
mounted
RQWKH($68QLYHUVDO
6WDQGXQOHVVWKH&3
3UREH3URWHFWRUFOLSLV
LQVWDOOHG2WKHUZLVHZLWKRXW
WKHSURWHFWLYHFOLSGDPDJH
WRWKHSUREHVW\OXVZLOO
result.
)LQH$GMXVWPHQW
&RDUVH+HLJKW$GMXVWPHQW
(on back of bracket)
CP-96 Probe
Protector Clip
