Mahlkonig K501, Руководство по эксплуатации

Страница: 15 / 20

|
L A D E N M Ü H L E N S H O P G R I N D E R
10. If the disc casing does not sit tightly after reassembly, readjust the
eccentrics by slightly loosening and tightening them again care-
fully with a screwdriver. They tighten automatically when screwed
back on.
11. Reassemble the spout. Push the two pins into the holes of the disc
casing cover and push it against the grinder body. Pull it down into
place. Reinsert the key plate.
7. For the rotary disc in the lower part of the casing place the service
tool on top. It locks in with the three eccentrics. Use the disc key to
loosen the thumb screw in the middle.
Take off the old disc.
When fitting the new disc, make sure that the disc
carrier is completely clean. If the discs do not run
plane, the grind adjustment will be misaligned.
8. Tighten the thumb screw with the special disc key again.
9. Replace the cover of the grinder casing and re-lock it by turning it
to the right until the insert for the spout is facing to the front.
Seite 14