MAHLE CML-7, Руководство по эксплуатации

Страница: 19 / 44

Operation CML Series | 19 | en
8.11 Single/paired operation
In some situations, it may be desirable to place only one
wheel or one axle on stands instead of placing the entire
vehicle on stands. The lift system features a special mode
of operation called single/paired mode to allow this. The
system can be placed in single/paired mode at any
height.
1.
If only one wheel of the vehicle will be placed on a
stand, position yourself at the lift unit that is
positioned on that wheel of the vehicle. If one axle
will be placed on stands, position yourself at one of
the lift units on the ends of the axle to be supported.
2.
Push the
SINGLE
/PAIRED
button
on the main
operation screen shown in Section 8.5.
3. A screen will appear asking whether the system will
be operated in single mode or paired mode. If only
one wheel will be supported on stands push the
SINGLE
button. If one axle will be supported on
stands push the
PAIRED
button. Pushing the
EXIT
button will return to the main operation screen.
4.
The screen shown below (paired mode is shown in
this example, single mode would be similar) will be
displayed on the lift unit where single or paired
mode was initialized. All other lift units will be
locked out from operation and show a screen
indicating this condition.
Fig. 11: Paired mode operation
5.
All the buttons shown function in the same way as
described in Section 8.5 and 8.6. The vehicle can
be raised or lowered as needed to place stands and
support the vehicle. The distance the vehicle can be
raised or lowered is limited while in single or paired
mode.
6.
When all work has been completed that required
the wheel/axle to be supported on a stand(s), move
the lift unit(s) back into position under the wheels.
The lift unit(s) can be raised or lowered to help with
properly positioning the lift carriage under the
wheel(s). Push and release the
ENABLE
button
and then within 5 seconds push and release the
AUTO
RETURN
button. The lift unit(s) that was
raised or lowered in single or paired mode will
automatically adjust its height to match the other
units in the system and support the vehicle.
7.
Once the lift(s) has adjusted its height to match the
rest of the system, all the screens will return to the
screen shown in Section 8.5. The system will now
operate as a whole with all lift units raising or
lowering together.