MAHLE CML-7, Руководство по эксплуатации

Страница: 14 / 44

en | 14 | CML Series
Operation
8.
The display will now appear as shown below (Fig. 8) with
a picture of a vehicle asking for the current lift unit’s
position relative to the vehicle. Select the round button
with a number inside it that matches the current lift unit’s
position. Once the position is selected the position
button will turn green to indicate the selection.
Fig. 8: Enter lift position in relation to vehicle
9.
Now move to the second lift unit (the units can be turned
on in any order) and turn the master on/off switch to the
ON
position. The same screen shown in Fig. 7 above
will appear after the screen has completed its startup.
10.
Select the same radio setting as was chosen in step 4
by sliding the settings buttons up and down on the right
side of the screen. When the correct radio setting is
highlighted, push the
CONFIRM
button
.
11.
The display will now show the same screen as shown
in Fig. 8. Select the round button that matches the
position of the current lift unit relative to the vehicle.
Positions that have already been selected will be shown
by a yellow-colored button.
12.
Repeat steps 9 through 11 on all remaining units that
will be used in the current lifting system
.
13.
If operating in
NORMAL MODE
, once all the units in
the lifting system are initialized (radio settings and
position relative to the vehicle selected) the screen on
all units will appear as shown below. Some of the
adapter modes will show a different screen that
requires additional setup before lifting the vehicle. If
any error messages are shown during initialization
consult the “Troubleshooting” section on page 32.
NOTE: If at any time the screen is not touched for more
than 5 minutes the screen saver will be activated. The
screen saver will display the battery voltage of all the
lifts in the system to help identify any lifts that may
need to be charged. To exit from screen saver mode
simply touch anywhere on the screen.
Fig. 9: CML main screen