TPS I and III for Eurosystem
Operations
D1 1004BA1-GB03
15
3.4
TPS III (Motorcycle)
3.4.1
Speedometer Test with Self-Contained Drive
The speedometer test can be conducted by using the keyboard or the remote control. If a
remote control is not available, a second person will be needed to perform the test.
Switch-on / Preparations
1 Switch on main switch on switch cabinet.
2 Press ON-key. After a 30-sec. self- check, the test stand is ready for operation.
3 Drive the front wheel of the motorcycle onto the roller set. Use restraining straps to tie down
the motorcycle at the sides.
Conducting the test
Rotating test stand rollers are potentially dangerous! Risk of injury!
1 Start the electric motor of the speedometer tester using the potentiometer of the manual
control device. Use the manual control device to adjust the speed from 0 - 150 km/.
e.g.: turn the setting regulator until the speedometer of the motorcycle shows 50 km/h and
press the 50 km/h key on the manual control device.
See section 3.2.1 for the speedometer test or section 3.2.2 for the distance test.
Switch-off
1 After the test is completed, turn the setting regulator on the manual control device to 0 km/h.
2 Press OFF-key to disable the electric motor.
3 Open the clamping device completely and exit the test stand.
