Operations
TPS I and III for Eurosystem
16
D1 1004BA1-GB03
3.4.2
Speedometer Test with Separate Drive
The speedometer test can be conducted by using the keyboard or the remote control. If a
remote control is not available, a second person will be needed to perform the test.
Switch-on / Preparations
1 Switch on main switch on switch cabinet.
2 Press ON-key. After a 30-sec. self- check, the test stand is ready for operation.
3 Drive the rear wheel of the motorcycle onto the roller set. Use restraining straps to tie down
the motorcycle at the sides.
Conducting the test
Rotating test stand rollers are potentially dangerous! Risk of injury!
1 Start the motor of the motorcycle. Accelerate the motorcycle until the desired test speed has
been reached and press the corresponding key on the remote control or keyboard for
storage.
See section 3.2.1 for the speedometer test or section 3.2.2 for the distance test.
Switch-off
1 If the speed falls below 5 km/h, the tester is automatically off and the testing process is
finished.
2 Wait until the rollers have come to a standstill.
3 Open the clamping device completely and exit the test stand.
