MAGUIRE Weigh Scale Blender 4088, Установка, эксплуатация и обслуживание

Страница: 34 / 149

34
Check Out Procedure Diagnostics
If display fails to come on at all:
Check power to blender controller.
Check your model numbers on the Red Metal Tag:
If model number is not correct for you unit:
see the next page,
SELECTING CORRECT MODEL.
If display field located center screen shows randomly drifting numbers:
check to see load cells are plugged in.
If display shows about (- 1250.0 g) or ( -4500 g):
check that the weigh bin is in place properly.
If display is steady but not near zero:
An over stressed load cell will display a permanently high or low reading. Recalibrate load
cells; next section.
If there is no response from the display when the bin is touched:
check for damaged wires to load cells.
check that load cell plug screws are secure.
If response is not sensitive or does not return to its start point:
check for interference around weigh bin.
If display says INVALID after entering the password number:
you pressed the wrong keys or the password number has been changed and it is no
longer 22222. Call us for help.
If an air solenoid does not operate:
check the 10 amp fuse.
check solenoid cable connected properly and fully seated.
check mix chamber door closed, safety interlock engaged.
If a slide or dump valve does not open:
check the air supply and regulator adjustment:
80 psi (5.5 bar) recommended.
check for proper air line connection to cylinder.
If an auger feeder motor does not run:
check the 3 amp fuse.
check that the motor is plugged into the proper outlet.
check for faulty motor by plugging it into a known source of 110 volt A.C. power (240 volt
outside U.S.).