MAGUIRE Weigh Scale Blender 4088, Установка, эксплуатация и обслуживание

Страница: 135 / 149

135
Load Retry - The number of times the receiver will try to successfully load
material and satisfy the sensor. Exceeding this retry count will cause the receiver
to alarm.
Dump Time - The time in seconds that the receiver will remain open during the
dump cycle.
Pump Assignment - The ID number of the pump that this receiver is assigned to.
Pulse Time
– For use with a bag filter or bridge breaker. Pulsed on-time in tenths
of a second that the Bridge Breaker output (output 6) will pulse on/off during
Dump Time. (see Flexbus Receiver Card Wiring Diagram, Output 6). Increasing
the Dump Time will increase the number of pulses.
Purge Time - The time in seconds that the purge valve will open to purge the
convey line. (Purge time follows Load time).
LEVEL
SENSOR
Level Sensor
–
Enables the use of an upper level sensor connected in series with
the demand signal. See Receiver Wiring Diagram
Priority - Sets the order of importance of the receivers. Setting
a receiver to level 1 sets to the highest priority, while setting to
level 5 sets to the lowest priority. Higher priority receivers
receive material first while lower priority receivers receive
material later.
Purge - This symbol represents the purge valve. When purging, the
symbol will show a blue arrow.
The Receiver's label and defaults can be reset by touching the large receiver
image in the center of the screen.