Magtek ExpressCard 2000, Руководство пользователя по установке и эксплуатации

Страница: 53 / 84

7 - Maintenance
ExpressCard 2000| Instant Issuance Card Personalization System | User Installation and Operation Manual
Page 53
7.1.3 About Cleaning the Card Cleaning Roller
The EC2000’s card cleaning roller, located below the image printer’s ribbon, removes lint and other
particles from the surfaces of card stock before printing. These particles accumulate on the card cleaning
roller over time and must be wiped off. If a cleaning roller is damaged or worn, it should be replaced (see
section
7.2 Replacing the Card Cleaning Roller for details).
7.1.4 How to Clean the Card Cleaning Roller
To clean the card cleaning roller (see this YouTube video for a demonstration):
1) Obtain a card cleaning roller wipe from the EC2000 Cleaning Kit.
2) Remove any jewelry or accessories that could touch the print head during cleaning.
3)
Open the EC2000’s top access door (see section
6.5 Top Access Door Security ).
4) Open the image printer and remove the ribbon (see section 6.8 Image Printer ).
Figure 7-1 - Removing the Card Cleaning Roller
5) Remove the cleaning roller (see Figure 7-1 ).
6) Unwrap the wipe and rub it gently over the entire surface of the roller. Pay special attention to spots
that feel uneven, which may be dirt or dust stuck to the roller. If there are any uneven or rough spots
you can not wipe off, contact MagTek Support Services for assistance.
7) When the card cleaning roller has dried, re-install it into the image printer.
8) If you have not already done so, clean the card path and print head.
9) Re-install the image printer ribbon.
10) Close the image printer (see section 6.8 Image Printer ), and close the top access door.
11) Re-synchronize the image printer ribbon (see section 6.8.4 How to Select and Synchronize the
Image Printer Ribbon ).
12) Create a sample card (see 6.11.1 How to Create Sample Cards ).
13) Press the Status button to return to the Status menu.
7.1.5 About Cleaning the Card Path
The path cards travel through the EC2000 should be cleaned regularly (see section 6.11.6 About the
Card Path / Sequence of Processes ). The card path includes:

The manual feed slot,

All feed rollers,