8 - Configuration
ExpressCard 2000| Instant Issuance Card Personalization System | User Installation and Operation Manual
Page 67
Users can use an Internet-based card personalization service, such as QwickCards.com. In this case,
the EC2000 must be set up to poll the personalization service regularly using SSL over the Internet to
retrieve transactions.
Depending on which of these is selected, the EC2000 may need to be configured to either receive
transactions directly, or to regularly check for incoming transactions. Additionally, if the EC2000 has
been set up with a data key (contact MagTek Support Services for details), the card personalization
software which creates transactions must encrypt them using the same key.
See the sections below for steps to set up the EC2000 in these situations. For information on setting up
and using the card personalization software used to send transactions to the EC2000, see that software’s
documentation or contact the company that provided the software. For information on implementing card
personalization software that can send transactions to the EC2000, contact MagTek Support Services and
request the set of manuals and references for programming the EC2000.
8.6.2
How to Set Up LAN-based Processing
Reserved for future content.
8.6.3
How to Set Up Internet-based Processing
To set up the EC2000 to regularly poll QwickCards.com for transactions:
1)
Determine the EC2000’s serial number (see section
2)
Contact MagTek Support Services.
3)
Support will walk you through a process that includes
Menu
>
Settings
>
Service
>
Qwickcards
,
reading them a challenge code, and entering a passcode to enable the device.
4)
When complete, the EC2000 will display a QwickCards Settings page similar to that in
Figure 8-2 - QwickCards Settings Page
5)
Press the
Save
button to commit the configuration changes.
6)
See the QwickCards documentation for information about adding and configuring the device to make
it available in the list of issuance locations.
