40
A proper draft setting is crucial to the successful burning of solid fuels. Draft refers to the amount of air
flowing through the burn chamber/firebox of your unit. Too much or too little draft will cause your unit
to burn improperly and may result in the fire burning out. Please follow these guidelines carefully as you
operate your unit to achieve maximum efficiency and enjoyment.
9
The amount of draft required for your unit to burn properly will depend upon your installation and the
fuel you use. You can set your draft by looking at the flame and following these guidelines. The
manual draft knob is the rod and knob on the left side of the unit. Pulling the knob out increases the
draft and pushing the knob in decreases the draft. A little movement of the knob goes a long way to
changing the flame. It may take several trial and error adjustments on the draft to achieve the correct
setting.
9
The flame should be an “active” flame. A flame that moves around lazily and emits visible smoke
needs more draft. To give the fire more draft, pull the damper out 1/8” and check the flame again. If
the status of the flame has not changed, move the damper another 1/8” until you get a clean “dancing”
flame.
If moving the damper does not change the fire, you might have negative pressure in the
home.
9
The base of the flame should be blue in color and the top of the flame s
yellow.
9
If the flame does not have enough draft, fuel will build up in the firepot and ev
flame. If this happens, or if you notice the firepot is filling
damper 1/8” at a time until the fire is clean and dancing. If this continues and m
does not change anything, you probably have a negative air problem and should
inspect your installation.
Do not operate the unit if smoke is being pulled into the h
9
If the flame has too much draft, the flame will look like a torch in that it will be
blowing fuel out of the firepot. If you find that you have this condition, move the
at a time until the condition of the flame changes.
9
If the fuel crusts over, you will need to check into the fuel quality. This will also
do not have outside air hooked up or if your home is starving for fresh air.
SETTING THE DRAFT
hould be white will some
entually smother the
up with partially burned fuel, open the
oving the draft knob
have a service tech
ome.
moving rapidly and
damper inward 1/8”
be a problem if you
Содержание Winchester WINACI
