Magnum Industrial MI-93050, Руководство пользователя

Страница: 12 / 22

- 10 -
7. Operating
Information Before Operation
Be sure the blade isn’t in contact with the
work when the motor is started.
Run the motor, allow the saw to come to full
speed. Begin the cut by letting the head down
slowly onto the work.
DO NOT DROP OR FORCE. Let the weight
of the saw provide the cutting force. The saw
shuts off at the end of the cut automatically.
Rate of Feed
The rate of feed is preset (On Mark H) at the
factory for solid metal material cutting.
To decrease feed, proceed as follows:
1. Release the lock-pin by pulling up the
Knob (A) in Fig.3 a little bit.
2. Turn the wheel (B) toward the Knob and
stop on the Mark M, let the lock pin slide
in the slot. The rate of feed is for thick
metal pipes cutting.
3. Turn the wheel and stop on the Mark L
and lock it on the position, the rate of
feed is for thin metal pipes cutting.
Angle Cutting
The machine uses a swivel miter base for
angle cutting from 0~45 degree. On the
swing arm, there is a pointer (A) in Fig.4
attached. This machine is preset zero degree
before leaving the factory. Angle cutting is
adjusted as follows.
1. Loosen bolt (B) to release the arm.
2. Move this swivel arm forward along the
scale to search a right index for the work
to be cut.
3. If the pointer matches the right index on
the scale. Tighten the bolt, and a perfect
angle cut will be given.
Blade Direction of Travel
Be sure this blade is assembled to the
wheels so that the vertical edge can engage
the work piece first.
Blade Movement