Magnum Industrial MI-93050, Руководство пользователя

Страница: 16 / 22

- 14 -
8. Adjustment
Adjusting Blade Guide
An unbounded handle is mounted on the unit
for freely adjusting the position of blade guide
to suit the workpiece size. It’s designed for
your convenience to adjust blade guide easily
and quickly at any time, and under any
situation. Adjustment of this blade guide is in
accordance with the sizes of work pieces.
The one located at the left of the saw head
can be adjusted and the other is fixed.
1. If the work is big, loosen the handle (A) in
Fig. 8. Move the guide toward the work
about one inch then tighten the handle.
2. When cutting a small work, move the
guide toward the work as close as it can
be. Both cuttings will present you
satisfactory jobs.
WARNING
Do not make any adjustments, or load,
unload work from vise when machine is
running !
Adjusting Poor Cutting
The machine has been adjusted and
power-tested with several test cuts before
leaving the factory to insure proper cutting. If
there is any poor cuts occurred, correct it as
follows.
1. Bad cuts due to blade worn, replace a
new blade.
2. The saw uses fixed ball bearings. For
keeping proper cutting, the best way is to
replace them every three or six months
depending on the frequency of service.
3. Poor cuts can be made because the fixed
nut (A) is getting loose. Then tighten it
properly.