Magnum Industrial MI-93050, Руководство пользователя

Страница: 18 / 22

- 16 -
Adjusting Blade Tracking
WARNING
Blade tracking adjustment requires running
the saw with the back cover open. This
adjustment must be completed by qualified
persons only! Failure to comply may
cause serious injury!
Note: Before making any tracking
adjustments, try a new blade. Warped
blades will not track.
Blade tracking has been set at the factory
and should not require adjustment. If a
tracking problem occurs. Adjust the
machine as follows:
1. Move the saw arm to the vertical position
and lock in place.
2. Confirm that blade tension is set properly.
To adjust, see section titled “Adjusting
Blade Tension”.
3. Open the back cover by loosening the
hinges.
4. Run the machine and observe the blade.
Blade should run next to, but not tightly
against the wheel flange.
5. Loosen the bolt (A) in Fig.10.
6. While observing the tracking on the blade
wheel. Turn both of the set screws (B)
clockwise about 1/4 revolution to track the
blade closer to the wheel flange. Turn
the set screws (B) counter-clockwise 1/4
revolution to track blade away from the
wheel flange. Once tracking is set,
tighten bolt (A).