Magnum Industrial MI-91350, Руководство по эксплуатации

Страница: 17 / 24

16
MAINTENANCE
MAGNUM INDUSTRIAL MI-91350 DELUXE 14" WOOD BAND SAW
PERIODIC MAINTENANCE and LUBRICATION
Lubrication
Keep the RACK AND PINION (A) and BLADE TENSION ADJUSTMENT SCREW (B)
well greased and free of dust and debris.
Clean and remove dust, debris and old grease after every 10 to 15 hours of use. After
cleaning, re-apply grease as needed. Use any all-purpose grease.
The motor and all bearings are sealed and permanently lubricated. They require no
further lubrication. No other part of this band saw needs lubrication.
PERIODIC MAINTENANCE
• Inspect and test the ON/OFF switch before each use. Do not operate the band
saw with a damaged switch. Replace a damaged switch immediately.
• Periodically inspect the power cord, plug and the blade for damage.
• Keep the machine clean and free of sawdust. Frequently blow out or vacuum up
the sawdust and wipe down the machine occasionally with a damp rag.
Keep the band saw wheels and tires clean. Dirt and debris on the wheels can cause
the blade to slip.
• Do not allow dirt, pitch or gum to build up on the table, blade, guide and thrust
bearings. Clean as needed with gum and pitch remover. But do not immerse the
bearings in gum and pitch remover.
• To prevent rust from forming on the unpainted cast iron of the table, and so that
the wood slides easily while cutting, apply a light coating of paste wax or use
regular applications of any aftermarket surface protector or rust inhibitor.
WARNING!
Always disconnect the machine from the power source before performing any lubrication or maintenance.
WARNING!
If any part is damaged, do not use the band saw. Replace any damaged part
as soon as you notice the damage.
WARNING!
To avoid eye injury from blowing debris, wear safety goggles when blowing
out sawdust.
FIGURE 44: MAINTENANCE and LUBRICATION
48