6
INSTALLING THE TENSION LEVER HANDLE
Thread the
TENSION LEVER (A)
onto the
TENSION LEVER
SEAT (B)
. See Figure 8.
ATTACHING THE TABLE-TILT BRACKET
The table mounts on a bracket that can adjust from 0° to 45°.
Adjustments can be made with the angle scale and lock knobs.
To install the table-tilt bracket, complete the following steps:
1. Remove the two
HEX BOLTS (C & D)
and washers from
the lower wheel housing. See Figure 9.
2. Place the table-tilt bracket on the lower wheel housing and
align
HOLE (F)
and
HOLE (G)
with the threaded holes in the
lower wheel housing.
HOLE (E)
is not used. See Figure 10.
3. Place washers on the two
HEX BOLTS (C & D)
and insert
bolts through the table-tilt bracket holes and into the
threaded holes in the lower wheel housing.
4. Secure
HEX BOLTS (C & D)
using a 12 mm open end
wrench and 12 mm socket. DON’T OVERTIGHTEN. You can
tighten the table-tilt bracket after the blade is centered
and the table is correctly installed. See Figure 15 on the
next page.
5. Thread a nut onto the longer
TABLE-STOP BOLT (H)
and
screw the bolt into the hole on the rear tab of the table-tilt
bracket.
WARNING!
Serious personal injury could occur if you
connect the saw to the power source before
you have completed the installation and
assembly steps!
FIGURE 8: LOWER WHEEL HOUSING
ASSEMBLY INSTRUCTIONS
MAGNUM INDUSTRIAL MI-91350 DELUXE 14" WOOD BAND SAW
8
A
B
FIGURE 9: TENSION LEVER
9
FIGURE 10: TABLE-TILT BRACKET
10
C
D
C
D
E
F
G
H
WARNING!
This tool is for indoor use only. Do not expose
to rain or use in wet or damp locations.
Содержание MI-91350
Страница 1: ...MODEL NO MI 91350 OPERATING MANUAL ...
Страница 18: ...MI 91350 ASSEMBLY ...
Страница 19: ...MI 91350 ASSEMBLY ...