12
BASIC ADJUSTMENTS
MAGNUM INDUSTRIAL MI-91350 DELUXE 14" WOOD BAND SAW
BLADE REMOVAL (CONTINUED)
2. Remove the
TABLE ALIGNMENT PIN (I)
from the table
slot and the
TABLE INSERT (J)
from the centre of the
table. See Figures 31 and 32.
3. Remove the
BLADE GUARD (L).
Loosen the two
PHILLIPS
HEAD SCREWS (K)
just enough so you can slide off the
guard. See Figure 33.
4. Open the top and bottom wheel doors and bring the left
hand side of the loose blade toward you and out of the
left hand blade guard slot.
WEAR GLOVES
when handling the blade. See
Figure 34.
5. With the blade perpendicular to the wheels, feed the blade through the table
slot to remove it. See Figure 35.
USE CAUTION!
The saw blade is sharp!
6. Carefully hang the blade on a hook in a safe, dry place in your workshop.
Do not coil it. It could pop open unexpectedly. If the blade is worn or
damaged, dispose of it safely.
BLADE INSTALLATION
To install a blade, first turn off the saw and unplug the power cord. You may
want to wear gloves when handling the blade.
If you are installing a new blade, carefully remove the blade from its package.
Hold it firmly with one hand as you remove the twist ties. Slowly separate the
coils of the blade until it unravels into one hoop. Use caution. The blade could
pop open unexpectedly.
1. Remove the
TABLE ALIGNMENT PIN (I)
from the table slot and the
TABLE INSERT (J)
from the centre of the table. See Figures 31 and 32.
2. Remove the
BLADE GUARD (L).
Loosen the two
PHILLIPS HEAD
SCREWS (K)
just enough so you can slide off the guard. See Figure 33.
3. With the blade perpendicular to the wheels, guide it through the table
slot, then rotate the side of the blade nearest you back toward the left
side of the wheels.
4. Feed the blade into the left blade guard and around the wheels. Make
sure the blade teeth point forward and down. See Figure 36.
Once the blade is properly installed. Follow the instructions on the next page
to set blade tension.
31
FIGURES 31, 32 and 33: BLADE REMOVAL and INSTALLATION
34
FIGURE 34: BLADE REMOVAL
35
FIGURE 35: BLADE REMOVAL
32
33
36
FIGURE 36: BLADE INSTALLATION
WARNING!
To avoid injury, ensure the power switch is OFF and the power cord is
unplugged before adjusting the band saw.
Содержание MI-91350
Страница 1: ...MODEL NO MI 91350 OPERATING MANUAL ...
Страница 18: ...MI 91350 ASSEMBLY ...
Страница 19: ...MI 91350 ASSEMBLY ...