Magnetek Flex Pro Series, Инструкция по эксплуатации

Страница: 21 / 24

Flex Pro Tethered Controller Instruction Manual
April 2019
Page 21 of 24
7 OPERATING PROCEDURE
7.1 GENERAL OPERATING PROCEDURE
1. Reset the red emergency stop button located on the top left hand side of the controller
handset by rotating it either clockwise or counter clockwise. The red button will pop up.
Figure 9
2.
Turn on the controller power by inserting the black-colored key into the power key slot
located on the top right hand side of the controller handset and rotate it clockwise to
the “On” position.
Figure 10 Figure 11
3.
After turning on the controller power, check the Status LED on the controller handset for
any sign of system irregularities (refer to “Status Light Indicators & Warnings” on page 22).
If the system is normal the Status LED will light up green for two seconds, then slowly flash
green.
4. If there are no signs of any system irregularities, then rotate the power key further
clockwise to the “Start” position for up to two seconds. This will activate the E-Stop on
the equipment. Thereafter, the same “Start” position will become an auxiliary function with
momentary contact.
Figure 12