Magnetek Flex Pro Series, Инструкция по эксплуатации

Страница: 12 / 24

Flex Pro Tethered Controller Instruction Manual
April 2019
Page 12 of 24
4.3 TYPES OF BUTTONS
The buttons used on the Flex Pro tethered controller are fully proportional, stepless push buttons
with an output that varies 0-100% (based on how far the button is depressed). It is possible to
model the stepless buttons as an On/Off momentary switch, On/Off latched switch, 2 Speed button,
or a 3 Speed button. This modeling is done on the receiver end of the system. Please consult the
factory for more information.
4.4 ADJUSTABLE SPEED CONTROL
The proportional buttons normally operate on a scale from 0-100%, but can also be scaled down to
operate linearly from 0-75%, 0-50%, or 0-25% over the full motion of the button. This gives the user
more control over lower speeds. To adjust the speed control settings, press and hold the Start
button, then press push button 1 or push button 2 to decrement/increment the range percentage.
The red LEDs, which indicate the Speed Setting, will then change to reflect the current setting.
Figure 5 Figure 6
Start + Speed control setting
PB1 Decrement Speed Control
PB2 Increment Speed Control