MAGNEPLANAR MMC 2, Руководство по установке

Страница: 15 / 23

I Hookup
Connect the positive (red) speaker wire to the MMC 2 white and red wire. We
recommend that the connection to the speaker wire be soldered with shrink
tubing for electrical insulation. Check for correct phasing before making a
permanent connection.
In case you missed it in the manual-
A few hints when installing the Controller/Power Supply for the MMC 2-- 1)
Be sure to set the motor timer for approximately 2 seconds longer than is
needed to fully open or close the speaker panels. 2) Use equal length wires to
each motor so the voltage drop is the same to achieve uniform motor speed or
adjust the relative speed with resistors or a potentiometer. 3) Set the motor
voltage (speed) as slow as practical.
Revision-- 7-25-15 Page of 15 23