MAGNEPLANAR MMC 2, Руководство по установке

Страница: 5 / 23

d. Level the template by placing a level on the top or side of the template. See
Fig. 2. CAUTION- Take great care to ensure that the wall is plumb
(vertical) and the template is level before drilling the holes.
Th e speakers
will not close or open if severely out of plum or level. As an additional
precaution, tape the template into position once the template is level--and
recheck the level. Misaligned holes are a SERIOUS problem and will
require starting over with the installation in a di
ff erent location.
e. Drill a 1/4" dia. hole in the upper le ft corner of the template. Insert a 1/4"
dia. dowel in this hole. Maintaining the template in a level position, drill a
second hole in the bottom MIDDLE hole and install a dowel. Now, the
template will hang unassisted.
f. CAUTION- Double-check to be sure that the template is level. Th e 4
corner holes are hyper-critical. Once they are drilled, there is very little
adjustment that can be done to correct misalignment of the motor mounts.
Th e center top and bottom holes are access holes and are not critical to
proper alignment.
g. Install (4) PLASTIC sheet rock anchors in the outermost (4) holes. Center
holes are for wire feed only. (Do not use the metal sheet rock anchors. Th e
metal sheet rock anchors are provided for installations where the motors
will not be used.) If the provided plastic sheet rock anchors are used in
your installation, the 1/4 inch hole must be enlarged to 5/16 inch.
Important--Insert the plastic sheet rock anchors
fl ush with the wall.
h. Install (4) #8 x 1-1/2" screws into the sheet rock anchors with
approximately 3/16 inch clearance from the wall. USE HAND TOOLS
ONLY. NO POWER TOOLS!
i. Install painter's tape on the wall above the location of the top frame to
prevent marring of the wall while installing the top frame.
Revision-- 7-25-15 Page of 5 23