MAGNEPLANAR MMC 2, Руководство по установке

Страница: 17 / 23

Pull the MMC 2 out until you feel the slight resistance of the Cam/Stop. (Note-
If you do not feel the resistance of the Cam/Stop, the Cam has been rotated
180 degrees and the Cam must be rotated further until the Cam and Stop
intersect.) Insert the long 5/64 inch allen wrench into the Cam/Stop at the
bottom of the speaker as shown in Fig. 1 and 2 below and loosen the allen
screw. Rotate the MMC 2 to the desired position as shown in Fig. 3 and 4 while
holding the Cam/Stop stationary. It is necessary to raise the MMC 2 slightly to
remove the weight of the speaker o
ff of the Cam/Stop so that the speaker can
be rotated independently of the Cam/Stop.Tighten the allen screw. If the Cam/
Stop moves in the process of moving the MMC 2, the angle will be wrong. In
that case, another adjustment will be necessary.
Li ft the speaker panel as high as possible to expose the allen screws. Insert the
long 5/64 inch allen wrench into the allen screws in the Cam/Stop at the
bottom of the speaker as shown in Fig. 1 and 2. Loosen all but one of the allen
screws (Your cam may have 2 or 3 allen screws). Next, pull the MMC 2 out
until you feel the slight resistance of the Cam/Stop. (Note- If you do not feel
the resistance of the Cam/Stop, the Cam has been rotated 180 degrees and the
Cam must be rotated further until the Cam and Stop intersect.) Maintain the
speaker panel at the position where the Stop has hit the Cam. Li
ft the speaker
panel as high as possible to gain access to the allen screws. Insert the long 5/64
inch allen wrench into one tightened allen scew in the Cam/Stop. Loosen the
allen screw and
use the allen wrench to hold the cam at the same position
while you rotate the MMC 2 to the desired position. It is necessary to keep the
weight of the speaker panel o
ff of the Cam/Stop so that the speaker can be
rotated independently of the Cam/Stop. Tighten the allen screw. Invariably, the
Cam/Stop will move slightly in the process of moving the speaker panel and
the angle will be wrong. In that case, another adjustment will be necessary.
Th e
last step is to check the panel angle by using the Controller/Power Supply
which may not be the exactly the same as the manual setting.
Th e angle of the MMC 2 should never be set for less than 30 degrees for
optimum sound.
Revision-- 7-25-15 Page of 17 23