Magma
EB3600-AB | Chapter 2 Hardware Installation
36
Install PCIe card / GPU
Installation of a single-wide PCIe card or single-wide GPU is a straightforward process. However, when
installing multiple double-wide GPUs it requires strict methods that must be followed. See details below for
instructions on installation of double-wide GPU.
Installation of Singe-wide GPU
1.
Be sure to turn off your expansion unit and unplug it from the wall before you begin
2.
Remove filler bracket for the expansion slot you wish to use in the chassis.
3.
Align the new GPU card with the empty socket
4.
Gently push down evenly on both ends of the card until it is fully seated in the socket. Ensure that
the card’s rear-panel tab sits flat against the PCIe rear-panel opening
5.
Next, use a screw to secure the graphic card's metal retention bracket to your expansion unit
case.
Installation of Double-wide GPU
A double-wide GPU cover two slots. When installing multiple or 8 to 9 double-wide GPUs you must begin
placing the GPU in the far right of the backplane (looking from the rear). This will allow you to see the slot
location and align the GPU connector easily on top of the slot. Start installing the GPU one at a time from
right to left.
Содержание EB3600-AB
