3
Attach the unused portion at the supply side to the
other end at the take-up side using an adhesive
tape, while making sure that the joint surface is even
Top Side Film Cassette Bottom Side Film Cassette
4
Turn the take-up side using your hand until the
broken portion can no longer be seen
Top Side Film Cassette Bottom Side Film Cassette
5
Remove any slack in the laminate film
6
Insert the film cassette all the way in along the
guide rail until a “click” sound is heard, and close
the laminator door
Cautions:
Make sure to insert the film cassette all the way in until
a “click” sound is heard. Failure to do so may result in
defective patch or card jam.
If the film cassette is inserted upside down, it cannot
be inserted all the way in and the cassette button does
not lock in place. Also, you will not be able to close the
laminator door.
●
●
Misaligned Patch Position
The patch position may vary slightly with respect to the
card depending on the type of film used and the different
methods used during the manufacturing process. If the
patch position is not properly aligned, adjust it accordingly.
If patch position is displaced to the left/right
Left
Right
You can adjust the setting
on the status monitor of the
computer that is connected
to the card printer.
The maximum displacement of
the patch position is ±7 steps
from the standard position.
The patch position can be
adjusted to the left or right by
0.17 mm per step.
Change the value in the +
direction to move the patch
position to the left.
Change the value in the -
direction to move the patch
position to the right.
(
A
Page 22 “Status Monitor
Settings [Laminator] Tab Sheet”)
●
●
●
●
●
Cautions:
Setting the patch position to a position beyond the edge of
the card may result in card jams. Make sure to adjust the
patch position nearer to the center of the card.
If patch position is displaced to the front/back
Back
Front
Turning the patch position
adjustment mechanism of the
film cassette enables you to
adjust the patch position to the
front or back by 0.25 mm.
The maximum displacement of
the patch position adjustment
mechanism is ±1 mm from the
standard position.
Adjust the scale in the + direction to
move the patch position to the back.
Adjust the scale in the - direction to
move the patch position to the front.
●
●
●
●
-1
-0.5
0
+0.5
+1
Cautions:
Apply the above procedures if there is significant
misalignment in the patch position.
Do not rotate the patch position adjustment mechanism
over ±1 mm. Doing so may damage it.
●
■
●
■
●
●
Orange
Yellowish-
green
