Madill 1200, Руководство пользователя

Страница: 36 / 45

MADILL 1200
GENERAL INFORMATION ON LUBRICATION AND
MAINTENANCE
In order to properly protect your machine and get the best performance and longest life
out of it, schedules of preventive maintenance and lubrication must be adhered to. All
maintenance and lubrication schedules are guidelines based upon normal cycles under
average working conditions. When unusually severe working conditions or operations
are encountered, maintenance and lubrication frequencies must be increased. Operating
in extreme temperatures (hot or cold), under constant heavy load, operating intermit-
tently, or operating in very dusty conditions constitute severe conditions and operation.
LUBRICATION
Keeping your machine properly lubricated is the most effective way to prevent failures
and consequent costly repairs. The lubrication chart provides reference to all points
requiring lubrication, and to the recommended frequency of lubrication.
A. Keep all lubricants and lubricating equipment clean and free of contamination both
while in storage and while in use.
B. Clean all grease fittings and surfaces before applying a grease gun. Dirt on fittings will
be forced through along with the clean grease, and will cause accelerated wear and pre-
mature bearing failure.
C. Wipe of excess grease and other lubricants. Oily and greasy surfaces collect dirt
which may work its way into moving parts and cause wear and failures.
D. When greasing fittings under normal working conditions, apply grease until it appears.
Under extremely dirty or dusty conditions, apply grease to fittings until old grease has
been flushed.
Under no circumstances may the recommended lubrication intervals be exceeded.
Avoiding service intervals will be constituted as negligence and will void the war-
ranty on the machine.
FUEL TANK
Fill the tank daily with diesel fuel. Location of the filler cap is at the right center of the
machine.
HYDRAULIC OIL TANK
Check this daily for oil level. A sight glass is provided and located on the side of the
hydraulic tank. Clean hydraulic oil should be added by the replenishing pump. Never
overfill the system. Never run the machine with low oil because this may damage the
pumps.
ENGINE CRANKCASE
Check the level of the engine oil daily and add the proper oil as necessary (see the man-
ufacturer’s recommendations). Never operate the engine with low oil. Change the oil
filter at every oil change.
Page 12a Section One
RETURN TO INDEX