Madill 1200, Руководство пользователя

Страница: 4 / 45

MADILL 1200
SAFETY PRECAUTIONS
REMEMBER! SAFETY IS UP TO YOU!
The following are some safety tips that you should follow when operating the 1200 Feller
Buncher for the protection of the people who work around you and for your own protec-
tion.
BEFORE YOU START
Know your machine. Inspect it thoroughly. Keep it clean. Wear close fitting clothing and
protective items. Make sure protective guards are in place. Check height, weight and
width restrictions for your work area. Be sure you know about any hazards. Make sure
you agree with your signal person on hand signals.
STARTING UP
Make sure all controls are in proper position for starting. Check for warning tags. Start the
machine only from the operator’s cab and do not leave the cab while the engine is run-
ning. Warm the machine up gradually. Practice with the function controls. Report any
unusual noises or conditions for immediate repair. STOP ACCIDENTS BEFORE THEY
STOP YOU!
WHILE OPERATING
PAY ATTENTION! Know the working range of your machine. Know where any obstruc-
tions might be. Do not move the machine unnecessarily fast. Be sure everyone is in the
clear before moving any part of the machine. NEVER SWING OR POSITION ANY
ATTACHMENT OR LOAD OVER GROUND CREW OR TRUCK CAB. Never allow any-
one to ride on any attachment or load. Never attempt to operate the machine from any
position outside the operator’s cab. Never operate in a location where the machine or
load may contact electric power lines. DO NOT operate with right door slid open or any
other doors open. ALWAYS operate with seat belt fastened.
WHILE TRAVELLING
Make sure that no one is endangered before you make your move. Never get on or off
the machine while it is in motion. Lock the swing brake when you travel. Cross obstacles
at an angle and at low speed. Watch to see that your boom clears all obstacles.
WHILE OPERATING DISC FELLING HEAD
The operator must operate the disc felling head from inside the cab and he must remain
in the cab until the saw stops rotating completely. ALL PERSONNEL NOT IN THE CAB
MUST BE AT LEAST 100 METRES(300 FEET) AWAY AND NEVER CROSS IN FRONT
OF A SAW OPENING!! All observers should stand opposite to the side of the machine
where the chips are discharged.
BEFORE PERFORMING SERVICE
Place attachment on ground, shut off engine and remove keys from ignition. Attach a
“DO NOT OPERATE” tag in an obvious place in operator’s cab.
Section One
Page 2a
RETURN TO INDEX