Maclaren twin triumph, Инструкция по сборке

Страница: 11 / 16

3
EN
Instructions
IMPORTANT: • READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP THEM FOR FUTURE REFERENCE.
• APPLY BOTH BRAKES WHEN PARKING THE STROLLER.
• YOUR CHILDREN’S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW THESE INSTRUCTIONS.
1 TO OPEN THE STROLLER
A Release BOTH storage clips.
B Open out the stroller.
C Using foot, push BOTH footplates down fully to engage the primary locks.
CAUTION: Ensure that all locking devices are engaged before use.
2 TO OPERATE BRAKES
A TO ENGAGE BRAKES: With foot, push BOTH brake levers to the far right.
B TO RELEASE BRAKES: Push BOTH brake levers to the far left.
NOTE:
BOTH brakes should be applied.
CAUTION: Parking device shall be engaged during the loading and unloading of
children.
CAUTION: Ensure parking device is engaged before leaving the buggy unattended.
3 TO OPERATE FRONT WHEEL SWIVEL LOCKS
A TO LOCK SWIVELS: Align front wheels and press down on locking levers.
B TO UNLOCK SWIVELS: Raise locking levers.
4 SEAT BELT/SHOULDER HARNESS OPERATION
WARNING:
AVOID SERIOUS
INJURY FROM FALLING OR SLIDING OUT.
ALWAYS USE SEAT BELT.
TO FIT HARNESS:
A Pull shoulder straps over the childs shoulder then attach to the waist
clips by sliding strap loops onto the hooks.
B Insert both waist clips into the clasp, shoulder straps are secured once
the clips are fastened.
C Adjust strap lengths by sliding buckles. Belt and harness should be snug.
TO RELEASE HARNESS:
D Press the button on both the front and back of the clasp simultaneously
to release.
5 TO ADJUST SEAT RECLINE
A TO RECLINE SEAT BACK: Locate adjustment strap on rear of seat back.
Squeeze fastener prongs and pull apart.
B TO RAISE SEAT BACK: From rear of stroller push seat back to upright
position and insert fastener securely into clasp.
C Further intermediate adjustment can be made by shortening or
lengthening the strap.
D After adjustment, secure the loose strap by attaching the Velcro pads.
6 ATTACHING THE HOOD
CAUTION: Overloading may cause a hazardous unstable condition to exist.
Maximum carrying capacity of hood pouch - 1.1 lb (0.5kg.) per pouch.
A With stroller open, clip the hood to the handle tubes just
above the retaining rivets.
B Place the rear apron behind seat backs.
C Extend hoods and press down on both side hinges of each hood
to lock open.
D The hood is removed by firmly pressing down the hood release tabs.
7 TO FIT THE RAIN APRON
A Place the apron over the hood.
B Attach two eyelets (one each side) to the hood clips.
C Attach two eyelets (one each side) to the front legs.
8 TO FIT THE SHOPPING BAGS
CAUTION:
Overloading may cause a hazardous unstable condition to exist.
Maximum load 4.4lb (2kg) evenly distributed.
The stroller may be folded with the bags still attached but
all contents must be
removed.
Failure to do this could damage stroller and contents of shopping bag.
A Place bags on the ‘X’ frame under seat with lowest edge of bag at front.
B Attach front straps to front legs just below seats.
C Attach rear straps to rear legs just above horizontal tie bars.
9 REMOVING AND REFITTING THE SEAT LINERS
The seat liners may be removed for washing.
The seat liners are reversible.
A Unclip all shoulder and waist straps.
B Twist crotch strap buckle and feed up through seat base and liner holes.
C Detach Velcro retaining straps from seat rear and slide seat liner from
seat base.
D feed waist straps and shoulder harness straps through holes in liner.
E Reverse this procedure to refit the seat liner ensuring crotch strap buckle
passes through seat liner hole and seat base hole.
10 REMOVING AND REFITTING THE SEAT COVERS
Remove rain apron, hood and seat liners from stroller if fitted.
A Twist shoulder strap end buckles and feed through holes.
B Feed waist and crotch straps through holes.
C Unclip seat cover retaining straps.
D Unfasten seat fabric from handle tubes and seat base.
E Slide fabric from seat back and base.
F Reverse this procedure to refit the seat cover and harnesses ensuring
seat back support tubes are inserted into fabric fold.
11 TO FOLD THE STROLLER
Remove rain apron from stroller if fitted.
Ensure the seat back is in its fullest upright position and the hood
(if fitted) is folded back.
Remove contents of shopping bag.
It is recommended that the harness is fastened before folding the stroller.
A Ensure the seat backs are in the fullest upright position.
B Fold back the hood (if fitted).
C Using foot, lift up BOTH footplates to release primary locks.
D Push down on secondary lock lever.
E Grip handles and push forward.
F Compress folded stroller and engage BOTH storage clips.