Play Next
Enabling Play Next allows Start 8 input
(Connector 1, Pos. 9) to initiate playback of
the next valid message sequence. The first
start activation after power on will play
message 1. All operation modes are
supported and other start inputs (1 - 7) are
disabled.
7
Disable
Enable
Memory Protect
Allows the user to lock message memory so
that messages may not be accidentally
overwritten.
8
Disable
Enable
2.2.3.
Main Interface Connector
12 position pluggable terminal strip. Use for remote
activation of message playback, stopping messages, and
playing relay output. Activation can be made through
mechanical contact or open collector driver. 3mA
activation current.
1
Common ground for all inputs
2 Start 1 Input, connect to common for message 1 playback
3 Start 2 Input, connect to common for message 2 playback
4 Start 3 Input, connect to common for message 3 playback
5 Start 4 Input, connect to common for message 4 playback
6 Start 5 Input, connect to common for message 5 playback
7 Start 6 Input, connect to common for message 6 playback
8 Start 7 Input, connect to common for message 7 playback
9 Start 8 Input, connect to common for message 8 playback
10 Stop Input, connect to common to stop message playback
or recording
11 Play Relay Output, Common
12 Play Relay Output, Normally Open
2.3.2. Audio Sense Indicator
This green LED monitors the
presence of audio on recording
input. This is designed to
indicate that the audio level is
optimum for system
performance. It is not an
absolute reference that audio is
present or not.
Off
Audio signal is low or no
signal present
On
Signal present
2.3.3. Record Indicator
This red LED indicates that the
MacFi-se is in record setup
mode or is currently recording.
Off
System not in record setup
or recording.
Blink
Record setup mode
On
Recording
2.3.4. Record Setup Button
This push button configures the MacFi-se for record mode.
Pressing this button will cause the record LED to blink, verifying
the MacFi-se is in record setup mode. Depressing this button
while still in record setup mode will exit this mode and turn off
the record LED. Pressing the button in the middle of the
recording process will have no effect.
NOTE: If you have difficulty recording, verify Memory
Protect, Configuration Switch 8 is OFF ( ).
2.3.5. Start/Stop Button
This button will either start or stop the current message. This is
applicable to either record or play modes. Depressing Start/Stop
button while playing or recording will exit the mode and return
system to idle.
If a message is selected for playback, with its number displayed
on the Message Number Display, pressing this button will initiate
the message play. Pressing it again, while the message is
playing, will stop the message play.
12
17
Содержание MacFi-se
Страница 14: ...14 15...
