MacDon R113, Руководство оператора

Страница: 260 / 276

TROUBLESHOOTING
Symptom Problem Solution Refer to
Ground speed too fast Reduce ground speed.
3.16.4 Ground Speed, page 80
Roll gap too large for
proper feeding
Decrease roll gap.
Roll Gap, page 81
Roll gap too small
in thick-stemmed
cane-type crops
Increase roll gap.
Roll Gap, page 81
Baf fl e set too low Raise baf fl e.
Internal Intensity Baffle, page 88
Foreign object
between rolls
Disengage mower conditioner
and stop engine. When all
moving parts have completely
stopped, remove foreign object.
3.19 Unplugging the Mower
Conditioner, page 101
Cutting height too low
Decrease mower conditioner
angle to raise cutting height.
3.16.2 Mower Conditioner Angle,
page 77
Backing into windrow
Raise mower conditioner before
backing up.
3.12 Raising and Lowering
Mower Conditioner, page 58
Conditioner rolls
plugging
Rolls improperly timed Adjust roll timing.
Roll Timing, page 84
Rear de fl ector
bypassing or
dragging crop
Adjust rear de fl ector for proper
crop control.
3.16.7 Cutterbar Deflector, page
94
Forming shields
improperly adjusted
Adjust forming shields.
Forming Shields: Roll
Conditioner, page 86
, or
Forming Shields: Finger
Conditioner, page 92
.
Uneven formation
and bunching
of windrow
Roll gap too large Adjust roll gap.
Roll Gap, page 81
Cutting height
varies from one
side to the other
Float not properly
balanced
Adjust mower conditioner fl oat.
3.16.1 Mower Conditioner Float,
page 75
Broken, bent, or
dull blades Replace blades, or turn
blades over.
4.5.4 Cutter Blades, page 153
Ground speed too fast Reduce ground speed.
3.16.4 Ground Speed, page 80
Not cutting
short enough in
down crop
Cutting height
too high
Adjust to steeper mower
conditioner angle in order to
lower cutting height if
fi eld
conditions allow.
3.16.2 Mower Conditioner Angle,
page 77
Material being
pulled out by roots
when cutting,
tall crop leaning
into machine
Crop in conditioner
rolls before crop is cut
Increase roll gap.
Roll Gap, page 81
Insuf fi cient roll gap Adjust roll spacing.
Roll Gap, page 81
Damaged leaves
and broken stems
Roll timing off
Check roll timing and adjust
if necessary.
Roll Timing, page 84
169820
250
Revision A