MacDon R113, Руководство оператора

Страница: 92 / 276

OPERATION
Adjusting Roll Gap: Steel Rolls
1. Lower mower conditioner fully.
DANGER
Stop engine and remove key from ignition before
leaving operator's seat for any reason. A child or
even a pet could engage an idling machine.
2. Stop engine and remove key.
3. Loosen and back off upper jam nut (A) on both sides
of conditioner.
4. Turn lower nut (B) clockwise to raise the upper roll and
increase
roll gap (C).
NOTE:
The amount of thread protruding through the
jam nut indicates roll gap (C). Factory setting is
1/4 in. (6 mm) which equates to 1/4 in. (6 mm)
of roll gap.
NOTE:
When adjusting roll gap, be sure the same
amount of thread is protruding on both sides of
the conditioner roll to achieve a consistent gap
across the rolls.
5. Turn lower nut (B) counterclockwise to lower the upper
roll and
decrease
roll gap (C).
6. Tighten jam nuts (A) on both sides.
Figure 3.89: Jam Nut, Adjusting Nut, and
Roll Gap
Adjusting Roll Gap: Poly Rolls
The roll gap setting on poly rolls is more sensitive than on steel rolls because the poly rolls operate at smaller gaps
and the conditioning is less aggressive.
1. Lower mower conditioner fully.
DANGER
Stop engine and remove key from ignition before
leaving operator's seat for any reason. A child or
even a pet could engage an idling machine.
2. Stop engine and remove key.
169820
82
Revision A