MacDon M2170NT, Руководство оператора, Страница: 283 / 558

262171
263
Revision A
When the header is first attached to the windrower, the windrower controller receives a code from the header that
determines the knife speed range and the minimum speed.
The desired speed can be programmed and stored in the windrower so the knife will operate at the original set-point after
the header is detached and reattached to the windrower.
Refer to the header operator
’
s manual for the suggested knife speed for a variety of crops and conditions.
NOTE:
The knife speed cannot be set outside the range specified for each header.
Setting Knife Speed
Set the knife speed by using the HarvestTouch
™
Display. Knife speed is displayed in strokes per minute (spm).
DANGER
Ensure that all bystanders have cleared the area.
ϭϬϰϮϬϳϰ
A
Figure 5.145: HarvestTouch
™
Display - Header Run
Screen
1. To set the knife speed, engage the header to display header
run screen 1, and then press KNIFE SETTINGS icon (A).
ϭϬϰϮϬϳϮ
A
Figure 5.146: Knife Adjust Page
2. Use KNIFE SPEED arrows (A) to adjust the strokes per
minute (spm) value.
NOTE:
For information and suggested knife speed settings for a
variety of crops and conditions, refer to the header
operator
’
s manual.
OPERATION