MacDon M Series, Инструкции по разгрузке и сборке

Страница: 114 / 396

ASSEMBLING THE WINDROWER
CAUTION
Check to be sure all bystanders have cleared the area.
2. Start the engine and activate the HEADER DOWN
button (A) on the ground speed lever (GSL) to fully
retract header lift cylinders.
Figure 3.162: Ground Speed Lever
3. Activate the REEL UP switch (A) on the GSL to raise
the center-link until the hook is above the attachment
pin on the header.
IMPORTANT:
If the center-link is too low, it may contact the
header as the windrower approaches the header
for hookup.
Figure 3.163: Ground Speed Lever
4. Drive the windrower slowly forward until the boots (A)
enter the header legs (B). Continue driving slowly
forward until lift linkages contact the support plates in
the header legs and the header nudges forward.
5. Ensure the lift linkages are properly engaged in the
header legs and are contacting the support plates.
Figure 3.164: Header Leg and Boot
147962
100
Revision A