MacDon D1X Series, Инструкции по разгрузке и сборке

Страница: 73 / 108

214778
67
Revision A
5.10.2 Adjusting Reel Clearance
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine, remove key, and
engage safety props before going under header for any reason.
1001329
A
B
Figure 5.32: Outside Reel Arm
1. Shut down the engine, and remove the key from the
ignition.
2. Adjust outboard reel arm lift cylinders to set clearance at
outboard ends of reel as follows:
a. Loosen bolt (A).
b. Turn cylinder rod (B) out of clevis to raise reel and increase
clearance to cutterbar, or turn cylinder rod into clevis to
lower reel and decrease clearance.
c. Tighten bolt (A).
d. Repeat at opposite side.
1009601
A
B
C
Figure 5.33: Underside of Center Arm
3. For double reel: Adjust center arm lift cylinder stop (A) to
change clearance at inboard ends of reels as follows:
a. Loosen nut (B).
b. Turn nut (C) counterclockwise to raise reel and increase
clearance to cutterbar, or clockwise to lower reel and
decrease clearance.
c. Tighten nut (B).
4. Check measurements and, if necessary, repeat adjustment procedures.
5. Move reel back to ensure steel end fingers do not contact deflector shields.
6. If contact occurs, adjust reel upward to maintain clearance at all reel fore-aft positions. If contact cannot be avoided
after adjusting the reel, trim steel end fingers to obtain proper clearance.
7. Periodically check for evidence of contact during operation, and adjust clearance as required.
PERFORMING PREDELIVERY CHECKS