MacDon D1X Series, Инструкции по разгрузке и сборке

Страница: 71 / 108

214778
65
Revision A
5.10 Measuring and Adjusting Reel Clearance to Cutterbar
The minimum clearance between the reel fingers and the cutterbar ensures that the reel fingers do not contact the
cutterbar during operation. The clearance is set at the factory, but some adjustment may be necessary before operation.
The finger to guard/cutterbar clearances with reels fully lowered are shown in Table 5.2, page 65 .
1005640
X
Figure 5.27: Finger Clearance
Table 5.2 Finger to Guard/Cutterbar Clearance
Header Width
(X) 3 mm (+/- 1/8 in.) at Reel Ends
Single Reel Double Reel
4.6 m (15 ft.)
20 mm
(3/4 in.)
—
6.1 m (20 ft.)
20 mm
(3/4 in.)
—
7.6 m (25 ft.)
25 mm
(1 in.)
—
9.1 m (30 ft.)
55 mm
(2-11/64 in.)
25 mm
(1 in.)
10.7 m (35 ft.)
70 mm
(2-3/4 in.)
25 mm
(1 in.)
12.2 m (40 ft.)
—
25 mm
(1 in.)
13.7 m (45 ft.)
—
25 mm
(1 in.)
5.10.1 Measuring Reel Clearance
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine, remove key, and
engage safety props before going under header for any reason.
1. Park the header on level ground.
1019036
A
Figure 5.28: Fore-Aft Position
2. Set the fore-aft position to the middle position 5 on the
fore-aft position decal (A).
3. Lower the reel fully.
4. Shut down the engine and remove key from the ignition.
PERFORMING PREDELIVERY CHECKS