MacDon D1X Series, Инструкции по разгрузке и сборке

Страница: 29 / 108

214778
23
Revision A
3.3 Connecting Center-Link
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1. Stop the engine and remove the key.
1016889
A
B
Figure 3.15: Center-Link without Self-Alignment
2. Hydraulic Center-Link without Self-Alignment: Relocate
pin (A) in frame linkage as required to raise the center-
link (B) until the hook is above the attachment pin on the
header.
IMPORTANT:
If the center-link is too low, it may contact the header as
the windrower approaches the header for hookup.
1000754
A
B
Figure 3.16: Header Leg
3. Remove hairpin (A) from pin (B), and remove pin (B) from
header leg. Repeat on the opposite header leg.
CAUTION
Check to be sure all bystanders have cleared the area.
4. Start engine.
1015853
Figure 3.17: Header Float Springs
CAUTION
When lowering header lift legs without a header or weight box
attached to the windrower, ensure the float springs tension is
fully released to prevent damage to the header lift linkages.
NOTE:
If not prompted by the Harvest Performance Tracker (HPT)
display to remove float, remove float manually by doing the
following:
ATTACHING HEADER TO WINDROWER