Mac allister MBC3630, Оригинальное руководство пользователя

Страница: 33 / 48

EN
33
In
more
detail...
MBC3630 by MacAllister
General operation
Operation
1. Check the product, its battery pack and charger as well as accessories for
damage before each use. Do not use the product if it is damaged or shows
wear.
2. Double check that accessories or attachments are properly fixed.
3. Always hold the product by its handles. Keep the handles dry to ensure safe
support.
4. Ensure that the air vents are always unobstructed and clear. Clean them if
necessary with a soft brush. Blocked air vents may lead to overheating and
damage the product.
5. Switch the product off immediately if you are disturbed while working by other
people entering the working area. Always let the product come to complete
stop before putting it down.
6. Do not overwork yourself. Take regular breaks to ensure you can concentrate
on the work and have full control over the product.
WARNING! To avoid hazards never cut heavier weeds, brush and
similar vegetation with a thickness exceeding the capacity stated in
section ”Technical specification”!
Avoid contact with stones, wire, glass etc. that may cause injury to the
user! Inspect the blade regularly for damage, cracks or breaks!
Always replace a damaged blade!
Cutting
1. Attach the cutter blade (21) to cut heavier weeds, brush and similar
vegetation. Make sure that the guard (17) has been attached properly.
WARNING!
Kickback (blade thrust): When working with the blade
there is always a risk of kickback (blade thrust) if the cutting device
comes into contact with a hard object! Kickback (blade thrust) will
cause the sudden stalling of the cutting device, which in turn results in
the cutting device being forced in the opposite direction to the rotation
of the blade! Ensure that you retain a firm grip with both hands at any
sign of such kickback (blade thrust), pay attention and retain a firm
stance to avoid injuries!
Kickback (blade thrust) is more likely to occur in areas where it is
difficult to see the material to be cut!
Danger zone between 12 and 2 o’clock.