New Heading:
Change or type the desired
heading
value and click on
“
Go.
”
The
“
Stop
”
command
will
immediately stop the current
motion.
Change ID:
Changes the ID Byte as stored in the
controller. This can be used to identify a specific
controller board and controller based upon your
usage.
Limit Travel:
A graphical representation of allowable
range of the motion as defined by the current po-
sitioner type and the Soft Limits set in the Limit Travel
spinners located just below the graphic.
Limit Switches:
CCW / DWN or CW / UP defines
the number of degrees and tenths that the
CCW / DWN or CW / UP limit switch is physically
located from the known start heading.
Initial Cal Heading:
This defines the known starting
location in degrees. Normally a fixed location within
your standard travel pattern.
Find Hard Limit:
Once the determined hard limit is
chosen, whether it be CCW / DWN or CW / UP,
pressing the Find Hard Limit will run the positioner at
the slowest speed until it trips the limit switch.
The measured CCW /
DWN or CW / UP limit switch
value will then be saved in the controller for use by
the
Auto Cal
Function.
Display Brightness:
Changes the brightness level of the LED Display.
Firmware Version:
Displays the current firmware from the controller when connected.
Read Settings:
Button that will read the settings from the controller and re
-
populate the SETUP window.
Write Settings:
Writes any changes made to values in the SETUP Utility window that do
NOT
have their own
“
Change Button.
”
All values are re
-
read after a Write Settings.
Save to File:
Saves the current settings into a file for later recall and writing to a controller. This is a backup
mechanism so that you may save each controller
’
s settings into separately named files and recall them for later
use should the controller need to be replaced, or otherwise restored.
Read from File:
Reads the saved values from the specified file. Use Write Settings after a read in order to
restore the values back into a controller.
Reset from File:
Reads the saved values from the specified file. Use Write Settings after a read in order to
restore the values back into a controller.
Presets:
Reads the (10) current presets from the controller and displays them for change. You may change only
one preset at a time with the Preset Window.
13200
M2 SETUP UTILITY OVERVIEW CONTINUED...
