ON/OFF (POWER)
This button controls AC power to the control unit.
DIGITAL DISPLAY & DIGITS
#1: (full left) shows the selected
MODE
for operation or programming.
#2: Indicates the Positioner travel
SPEED
in relative numbers from 0 to 9.
#3: Indicates an
“.
Or
-
”
for a limit zone or a digit when programming in a high gear ratio.
#4,5,6,7: Indicates
HEADINGS
, Azimuth / Elevation / Polarity, in degrees and programming data.
“
MODE
”
BUTTONS
The
MODE
buttons are used to cycle through and select among (5) operational or
RUN
modes and 10
PRESETS.
See
RUN MODES
and
PROGRAM MODE
details following this section.
“
SPEED
”
BUTTONS
The
SPEED
buttons control the positioner
’
s rate of speed in relative increments.
“1”
is the slowest speed,
“9”
is
the fastest. The top button increases the speed, the lower button decreases the speed. The lowest speed
available
DEFAULTS
to
“1”,
but can be set to any number between
“1”
and
“9”
in the supplied M2 Setup Utility
Software. Speeds can be altered for travel in any of the run modes.
“
CONTROL
”
BUTTONS
The
“
CW
”
and
“
CCW
”
or
“
UP
”
or
“
DOWN
”
buttons, activate the positioners
’
direction in
MODE
“0”,
MODE
“1”
and
MODE
“2”.
These buttons are also used for
“
Auto Cal
”
and
“
Initial Cal Heading.
”
FRONT PANEL CONTROL OVERVIEW
Digital Display
Power Switch
Speed Buttons
Mode Buttons
Control Buttons
