HEATER UNIT CONNECTIONS
Remove the (8) 8
-
32 screws from the front limit
switch panel.
1/4”
Prepare the provided 2
-
Conductor Red &
Black 16AWG wire. Remove
(5
-
1/4”)
of
the outer grey jacket. Strip
(1/4”)
of
insulation from both the Red & Black
wires as shown.
Slide the prepared 2
-
Conductor Red & Black 16AWG wire through the cord grip from the front of
the panel. Route the Red wire to position
“
A
”
as shown below. Then route the Black wire to
position
“
B
”
as shown below. Tighten small flathead screws on the terminal strip. Place the front
panel onto the LSK enclosure and reinstall the (8) 8
-
32 screws. Tighten the cord grip nut on the
front of the panel.
5”
A
B