LXE MX1-IS, Справочное руководство

Страница: 16 / 164

6 MX1-IS Components
MX1 I-Safe Reference Guide E-EQ-MX1ISRG-F
Insert I-Safe Main Battery Pack
Important: Do not store replacement I-Safe batteries and/or MULTI-chargers in hazardous
locations.
Note: New batteries must be charged prior to first use . This process takes approximately three
hours in an LXE I-Safe MULTI-charger.
Note: The MX1-IS battery may be exchanged with a fully charged battery in a hazardous
location. The MX1-IS must be powered off before opening the Battery Door.
Figure 1-3 Open Battery Door
The MX1-IS battery compartment is located on the lower rear of the computer. Unfasten the
protective leather cover. Open the Battery Compartment door by pressing down on the door latch
slide tab at the top of the compartment. Remove the battery door.
There is no need to remove the pistol grip handle or the protective leather cover.
1. Battery Contacts
2. Battery Pack Tab
Figure 1-4 Inserting Battery Pack
This illustration shows the battery compartment with the door removed. The Battery Contacts (1)
provide the electrical link between the battery pack and the computer. Care should be used when
inserting or removing the battery pack so that damage does not occur to the contacts. If damage
does occur, cease using the unit until inspection or repair can be performed by a qualified
technician.
The Main Battery Pack should be inserted tab end (2) first so that the tab mates with the hole at
the top of the battery compartment. The battery will then lay inside the battery compartment but
will not be secure. To secure the battery, the battery compartment door must be in place and the
door latch locked. This provides the pressure necessary to hold the battery pack in place.
Note: There is no backup battery in the MX1-IS device.