LXE 8650, Руководство пользователя

Страница: 36 / 308

24 Introduction
Bluetooth Ring Scanner Guide E-SW-BLUESCANPG-A
Pairing Bluetooth Devices
When the Bluetooth Ring Scanner module pairs with another Bluetooth device, it means the
Bluetooth Ring Scanner module can send serial data to the other Bluetooth device.
Note: Bluetooth Ring Scanner module paired data is stored in non-volatile memory in the
module and data is saved over power cycles. Paired devices automatically reconnect
when power is applied.
LXE Bluetooth Devices
Method 1
Using the Bluetooth Ring Scanner assembly, scan the pairing barcode (Bluetooth MAC address of
the device) on the LXE Bluetooth device (e.g. handheld or vehicle mount unit).
The Bluetooth Ring Scanner module initiates the pairing process with the LXE Bluetooth device
and the devices are paired. The Bluetooth Ring Scanner module’s Bluetooth LED flashes every 4
seconds. This is the LXE recommended method for pairing.
Method 2
Using the ring scanner attached to the Bluetooth Ring Scanner module, and the barcodes in
Chapter 2 Bluetooth Module Programming , scan the Pairing Status | Enable Slave Mode barcode.
Using the LXE Bluetooth device (e.g. handheld or vehicle mount unit) access the LXEZ Pairing
control panel by tapping the Bluetooth icon on the Desktop (or the Taskbar or the Control Panel).
Open the Bluetooth Devices panel. Tap the Discover button to discover nearby Bluetooth scanners
and printers. Identify the scanner you wish to pair with by matching the Friendly name (LXE
Scanner – [MAC ID]) with the MAC address label on the scanner. Doubletap the Friendly Name
and select Pair as Scanner from the drop-down menu. Close the LXEZ Pairing application.
Notes:
•
Assumption is that the Bluetooth scanner parameters are at the factory defaults for the scanner.
•
When users can use any mobile device with any scanner -- When returning from a break or at
the beginning of a shift all users should pair a scanner with their mobile device using either of
the methods shown above.
•
When the scanner and mobile device pair successfully, the LXE Scanner Wedge automatically
sets Wedge Port 1 to be used by Bluetooth. If the mobile device is equipped with other
integrated or tethered scanners, they must be configured to use a Scanner Wedge Port other
than Port 1 if they are to be used when a Bluetooth scanner is paired.
•
When the Bluetooth Ring Scanner is paired to a device using a Bluetooth driver other than
LXEZ Pairing, the Bluetooth scanner serial data should be managed in accordance with your
other Bluetooth devices.
Generic Bluetooth Devices
1. Using the ring scanner attached to the Bluetooth Ring Scanner module, and the barcodes
in
Chapter 2 Bluetooth Module Programming , scan the following barcodes:
•
Restore Factory Defaults
•
Pairing Status | Enable Slave Mode
2. Using the ring decoder and the barcodes in the ring decoder-engine-specific chapter (e.g.
Chapter 3 SE955 Laser Barcodes ) configure the ring decoder to meet the requirements of
the targeted generic Bluetooth device.