ASSEMBLY OF HEADLIGHT SYSTEMS
SWEATBAND
(properly supported)
Module receptacle
Insert bottom first,
then snap in top
Headlight module
Module receptacle
Insert bottom first,
then snap in top
Headlight module
Figure 1
Fiber optic
cable
Grasp cable
here for
installation
and removal
Headlight
module
Joystick
Figure 2
SWEATBAND
HEADBAND
Fiber optic
cable
Grasp cable here
for installation
and removal
Headlight
module
Joystick
The Luxtec headlight assembly consists of a headlight with a variable spot module, a cushioned headband or
sweatband, bifurcated fiber optic cable and two gown clips.
3
Remember, the cable is made of glass fibers. When adjusting the cable on the headband, do no bend the
cable more than 60 degrees. The cable is designed to curve gently around the shape of the headband.
All illustrations are representative and may not reflect your actual model and accessories.
HEADBAND
(properly supported)
Remove the cable from the module by grasping the body of the module in one hand and the lower-most ridges of the
cable in the other hand and pulling them axially apart. Do not hold the cable by its leg(s) or strain relief.
To assemble, attach the headlight module by sliding the bottom of the
module clip into the module receptacle, then push the top in until it makes
an audible ”snap” (Figure 1). To attach the joystick, thread it into the
hole in the front of the headlight module.
To attach the fiber optic cable, insert the angled end of the cable into the
headlight module until it snaps into place (Figure 2). A bifurcated cable
fits into the cable clips on both sides and the rear of the headband or
sweatband (Figure 3).
Figure 1a
Ultralite
Module
P/N 00-1190
Iris
Adjustment
